Wagan 400W, Руководство пользователя

Страница: 5 / 9

www.wagan.com
7
Elite
™
400W Pure Sine Inverter by Wagan Tech
®
©2012 Wagan Corporation
All Rights Reserved
Wagan and wagan.com are trademarks used by Wagan Corporation
8
User’s Manual—Read before using this equipment
Battery Clip Adapter Cord – Up to 400 Watts Output
1. Connect just the red spade terminal of the supplied DC Battery Clip Adapter
Cord to the red stud terminal (+) on the rear of the inverter.
2. Connect the two battery clips to the battery.
Be sure to connect the clips to the correct polarity battery terminals. Reverse
polarity connection will blow the fuse in the inverter and can permanently
damage to the inverter. Damage caused by reverse polarity will void the
warranty.
3. Connect the Negative black (−) spade connector to the stud connector
on the rear of the inverter. There may be a momentary spark and the low
voltage buzzer may briefly sound.
4. Plug the AC appliance cord into the inverter’s AC receptacle, and/or your
USB appliance into the USB Power Port.
5. Place the ON/OFF power switch in the ON position. The green LED should
turn on, indicating the inverter is powered and operating normally.
6. While the Inverter is not in use, place the inverter’s ON/OFF Power Switch to
the OFF position.
Operating Issues: Television and Audio Equipment Suggestions.
Although all inverters are shielded and filtered to minimize signal interference, some
interference with your television picture may be unavoidable, especially with weak
signals. However, here are some suggestions that may improve reception.
• Make sure that the television antenna produces a clear signal under normal
operating conditions (i.e. at home plugged into a standard 110/120V AC
wall outlet). Also ensure that the antenna cable is properly shielded and of
good quality.
• Sometimes vehicle alternators produce some electrical noise. There are filters
available to mount on the alternator to reduce noise.
• Change the positions of the inverter, antenna cables and television power
cord.
• Isolate the television, its power cord and antenna cables from the 12 volt
power source by running an extension cord from the inverter to the television
set.
Battery Clip
Adapter Cord
DC Plug Adapter
Cord