User’s Manual—Please read before using this equipment
©2009 Wagan Corporation. All Rights Reserved.
Wagan and wagan.com are trademarks used by Wagan Corporation.
Follow instructions for a negative grounded system as indicated below:
Securely connect the positive (+) red clamp to the positive (POS,
P, +) terminal of the vehicle battery or the remote positive (+)
terminal if equipped.
Securely connect the negative (-) black clamp to the vehicle
chassis, engine block or a non-moving metal part of the vehicle
which is verified to be grounded. Do not clamp directly to
negative battery terminal, carburetor, fuel lines or sheet metal
body parts.
See jumpstarting step to continue.
Follow instructions for a positive grounded system as indicated below:
Securely connect the negative (-) black clamp to the negative
(Neg, N, -) ungrounded terminal of the vehicle battery.
Securely connect the positive (+) red clamp to the vehicle chassis,
engine block or a non-moving metal part of the vehicle which is
verified to be grounded. Do not clamp directly to positive battery
terminal, carburetor, fuel lines or sheet metal body parts.
See jumpstarting step to continue.
Set On/Off safety switch to “ON” after clamps are secure on battery
post.
Allow 2 or minutes of charging time. It is recommended to have a
second person to assist holding the unit securely in place during the next
steps.
Turn on the vehicle to attempt to start the engine. If the vehicle does not
start after 4 to 5 seconds of engine cranking, then stop. Wait to 4
minutes, and then try again. Repeat several times until the vehicle starts.
CAUTION: Excessive engine cranking can damage the vehicle starter
motor. If the engine turns but fails to start after several attempts, other
technical problems might be involved. Discontinue cranking the engine
•
a.
b.
c.
•
a.
b.
c.
.
8.
.
Содержание 2544
Страница 1: ...R Item no 2544 User s Manual 500 Peak Amp Jumpstarter with Air Compressor ...
Страница 2: ......