Waeco PerfectView M55LX, Инструкция по установке и эксплуатации

Страница: 34 / 256

Using the LCD monitor PerfectView M55LX, M75LX
EN
34
This control cable is used as a signal cable for the activation of a side camera when an
indicator is flashing, for example.
➤
If necessary, connect the CAM1 socket ( 9 ) of the connection cable to the plug of video
source 1 (e.g. reversing camera).
➤
If necessary, connect the CAM2 socket ( 10 ) of the connection cable to the plug of the
video source 2 (e.g. side camera).
➤
If necessary, connect the CAM3 socket ( 11 ) of the connection cable to the plug of
video source 3 (e.g. camera).
I
Connecting an additional reversing camera (trailer operation)
➤
If necessary, connect socket CAM4 ( 12 ) of the connection cable to the plug of the
additional reversing camera.
8 Using the LCD monitor
8.1 Switching on the monitor
➤
If the monitor is switched off, press the
P
button (fig. 0 2, page 6) to switch the
monitor on.
➤
The button lights up green.
✓
The picture appears.
8.2 Switching off the monitor
➤
Press the
P
button (fig. 0 2, page 6) to switch off the monitor.
➤
The button lights up red.
✓
The picture disappears.
NOTE
Observe the power consumption of the video system. The cameras are
equipped with heaters. A maximum current of 1.5 A can flow (three cameras in
heating mode). Use a disconnector switch for direct connection to the battery.
This allows you to disconnect the video system from the battery easily if you
are no longer using the vehicle.