Waeco PerfectView M55L, Инструкция по установке и эксплуатации

Страница: 32 / 236

Installing the LCD monitor PerfectView M55L, M75L
EN
32
Observe the following instructions when laying the connection cable:
 If possible, use original ducts for laying the cables, or other suitable options, such as
ventilation grilles. If there are no existing ducts, you must drill a hole of
∅
22 mm.
Check beforehand that there is sufficient space on the other side for the drill head to
emerge (fig.
2 , page 4).
 Cover the holes with the feed through (fig. b 1, page 7) in the base of the monitor
bracket.
 To prevent damage to the cables, when laying them ensure that there is always
sufficient distance to vehicle components which can become hot (lights, heaters,
ventilators etc.).

When laying the cables (fig.
3
, page 4), make sure:
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
Connecting the monitor as a reversing video system (fig. d , page 8)
➤
Lay the connection cable for the monitor bracket on the dashboard.
➤
Insert the plug of the monitor cable ( 2 ) into the socket ( 4 ) of the connection cable ( 3 ).
Wait until you hear the plug snap in.
A
➤
Connect the red and black cables of the connection cable to a suitable voltage supply:
– Connect the red cable (
5 ) to terminal 15 (ignition).
– Connect the black cable ( 6 ) to terminal 31 (earth).
➤
If the monitor is to be activated when reverse gear is selected, connect the green
cable (
7 ) to the positive cable of the reversing light.
I
➤
If the monitor is to be activated e.g. when the indicator is flashing, connect the
following control cable to a positive cable of the indicator:
– white cable (
8 )
I
NOTICE! Beware of damage
Make sure the polarity is correct when connecting to a voltage source.
NOTE
If voltage is present in the green cable ( 7 ), the reversing camera will be
activated automatically. The reversing camera has priority.
NOTE
If voltage is present in this control cable, the video input CAM2 will be activated.