Waeco PerfectView CSMarine, Инструкция по установке и эксплуатации

Страница: 21 / 92

Installation
Alignment of the camera
Depending upon use of the camera, it can be desirable to modify the vertical angle of the
camera, e.g. in order to view the ground or the bottom structure. Here the movable weight
on the camera allows proper alignment according to the following specifications (see D 2):
Position 1: 30° pointing-downward
Position 2: horizontal
Position 3: 30° pointing-upward
Operation
Check all connections for proper connection and the power supply for correct
polarity (see C).
Switch on the monitor with the button “POWER” (see E 1). Now the camera image should
appear. If there is only a bright screen instead of the camera image, then you must
ensure that the correct camera is selected (selector switch “C1” or “C2”).
The “BRI“ control for the picture brightness setting, and the “CONT“ control for setting the
contrast are also on the front of the monitor. These controls enable you to adapt the pictu-
re to your requirements and to suit the picture content (see E 2).
Switching on LED illumination
If the natural light is insufficient, you can switch on LED illumination on the camera.
Press the “LED“ switch to switch on the camera's LED illumination. The green LED under
the switch glows (see E 2).
Set the desired luminosity using the “DIMMER“ control (see E 2).
Switching off LED illumination
Press the “LED“ switch again to switch off the camera's LED illumination. The green LED
under the switch goes out (see E 2).
21
RV-Marine-2.qxd 26.03.2004 11:40 Seite 21