Waeco Mobitronics RV-RMM-153, Инструкция по установке и эксплуатации

Страница: 37 / 68

LCD Monitor Installing the LCD monitor
37
6.2 Installing the monitor
Warning!
Select the location of the monitor so that it cannot injure anybody
in the vehicle under any circumstances (e.g. sudden braking, road
traffic accidents).
Observe the following instructions during installation:
z Do not install the monitor in areas where your head may impact or in the
area that may be used by an airbag. This could cause injury if the airbag
opens.
z The monitor may not impair your vision when driving.
z The installation location should be flat.
z Check that there is sufficient room above the installation location to attach
the washers and nuts.
z Bear in mind the weight of the monitor. Provide reinforcement if necessary
(larger washers or plates).
It may be necessary to partially unscrew the vehicle ceiling to attach the
installation panel.
z Ensure that you can lay the connection cables and the extension cable to
the monitor.
The installation procedure is as follows:
➤
Press the installation panel against the vehicle ceiling and mark four drill
holes (see fig. 7, page 6).
➤
Drill a hole of 3 mm at the points marked previously.
➤
Fasten the installation panel to the vehicle ceiling with four self-tapping
screws (see fig. 8, page 6).
Depending on the thickness of the material, use the following self-tap-
ping screws: either 4 x 9.5 (fig. 4.6, page 4) or 4 x 16 (fig. 4.7, page 4) or
4 x 30 (fig. 4.8, page 4).
➤
Screw the monitor onto the installation panel (see fig. 9, page 7) with the
seven M3.5 x 10 Phillips screws (fig. 4.9, page 4).
➤
Insert the gasket into the lid of the LCD monitor.
RV-RMM-153_de_en_dk.book Seite 37 Freitag, 23. Januar 2004 2:20 14