MagicTouch MT200
Learning or unpairing the hand-held transmitter
13
Unlocking the central locking system
➤
Press the “Unlock” button on the hand-held transmitter.
✓
If the ignition is switched off, the hazard lights flash twice to confirm.
8
Learning or unpairing the hand-held transmitter
MagicTouch can be operated using up to 10 hand-held transmitters. If a new hand-
held transmitter needs to be learned, all other transmitters will have to be paired
again
.
Proceed as follows for learning a new hand-held transmitter:
To switch to learning mode:
➤
Use a hand-held transmitter to unlock the vehicle.
➤
Take a seat in the vehicle and leave the door open.
➤
Schalten Sie die Zündung ein.
➤
Press and hold down the “SET” button on a hand-held transmitter already
paired.
➤
Switch the ignition off.
➤
Release the button.
✓
The hazard lights flash 10 times and then remain lit.
✓
The system is now in learning mode.
I
NOTE
If you do not press a button within 10 seconds, you will exit the learning
mode.
Learning the hand-held transmitter
Learn all the hand-held transmitters which you would like to use during this phase.
This also applies for the hand-held transmitters which you have already been using!
➤
Press the “SET” button on the hand-held transmitter.
✓
The hazard lights turn off while the value is saved.
✓
If the LED indicator and the hazard lights light up continually again after
2 seconds, then the hand-held receiver has been learned and you can now pro-
ceed with the next one.
I
NOTE
Only exit learning mode when you have learned all the hand-held receivers
you wish to use. Hand-held receivers which you do not learn during this
phase will be automatically unpaired from the system. They can only be
used again once they have been learned again.
To exit learning mode:
➤
Switch on the ignition.
_MT200.book Seite 13 Montag, 19. Juli 2010 7:28 19