MagicComfort MSH200
Installing the seat heater
23
Preparing the heating elements
A
NOTICE!
Insulate all the trimmed ends with the insulating material supplied
to prevent a short circuit.
I
NOTE
You can cut the heating elements to the required length and
shorten the lengths of the two conductor paths.
You can cut out a section of the heating element in the area of
the anchoring grooves on the seat or the backrest. Make sure
the cut-out sections are only made between the two conductor
paths (fig.
5
, page 3).
Do not cut the mat lengthways, otherwise it will not be heated in
the area of the incision (fig.
5
, page 3).
The heating surface on the backrest only needs to extend
approx. 30 – 35 cm above the seat, as the driver only leans
against this area when sitting normally (fig.
6
, page 3).
➤
Place the heating elements on the seat and backrest.
➤
If there are anchoring grooves in the seat or the backrest, mark these
areas on the heating elements.
➤
Mark the required lengths. Take into account the depth of the anchoring
grooves, if present. The heating element is inserted in these anchoring
grooves.
➤
Trim the heating element to the required length.
➤
Customise the cut-out sections as required.
➤
Insulate
all
the trimmed ends with the insulating material.
Installing the heating element for the seat surface
➤
Insert the heating element for the seat surface between the cover fabric
and the foam core of the seat (fig.
b
, page 4).
➤
If anchoring grooves are present, make sure that the cut-out sections are
positioned over the anchoring grooves (fig.
c
, page 4) and place the
heating elements in the anchoring grooves.
➤
Fasten the heating element using double-sided adhesive tape to prevent
it sliding on the foam core.
Ensure that no creases or kinks form.
_MSH200.book Seite 23 Freitag, 9. Dezember 2011 5:51 17
