Safety and installation instructions
magic watch
32
When the negative terminal of the battery is disconnected, all data stored in
the volatile memories will be lost.
z
The following data must be set again, depending on the vehicle
equipment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
Observe the following installation instructions:
z
Secure the parts of the MAGIC WATCH system installed in the vehicle
in such a way that they cannot become loose under any circumstances
(sudden braking, accidents) and cause
injuries to the occupants
of
the vehicle.
z
To prevent damage, when drilling ensure that there is sufficient room for
the drill head to come out on the other side (see
2
, page 4).
Observe the following instructions when working with electrical parts:
z
When testing the voltage in electrical cables, only use a diode test lamp
(see
1
5, page 3) or a voltmeter (see
1
6, page 3).
Test lamps with an illuminant (see
1
9, page 3) consume voltages which
are too high and which can damage the vehicle's electronic system.
z
When making electrical connections, ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp edged ducts without protection (see
3
,
page 4)
z
Insulate all connections.
z
Secure the cables against mechanical wear with cable binders or
insulating tape, for example to existing cables.
MWE-850-XXL-4.book Seite 32 Freitag, 8. Juli 2005 10:29 10
