Waeco coolair rt880, Руководство по установке

Страница: 32 / 260

EN
Installation CoolAir RT880
32
6.2 Steps for installation
A NOTICE!
 The manufacturer only assumes liability for parts included in the scope
of delivery. The validity of the warranty expires if the device is installed
together with third-party parts.
 Check whether the roof of the vehicle is able to support the weight of
a person before climbing onto it. Ask the vehicle manufacturer about
the permitted roof loads.
6.2.1 Removing the sunroof
➤ Remove all screws and fixtures of the existing sunroof.
➤
Take out the sunroof.
➤
Remove the sealant around the opening, so that the surface is clean
and free of grease.
I
NOTE
Dispose of all waste material, glue, silicone and seals separately.
Observe the local disposal guidelines.
6.2.2 Preparing the unit fastening
➤
Enlarge the existing  6.5 mm drill holes for fastening the sunroof to
a diameter of 8.5 mm (fig. 5 5, page 4).
6.2.3 Preparing the unit
A NOTICE!
During preparatory work on the surfaces, secure the unit from falling
down.
Make sure that the work surface is clean and level to ensure that the unit
is not damaged.
➤ Place the air conditioning roof unit on a work surface with the housing
facing down.
A NOTICE!
Screw in the thread insert vertically.
Do not exceed the screw torque of
 8 Nm for M6
 10 Nm for M8