WACO VC1803, Руководство пользователя, Страница: 7 / 38

NOTE: Fan will continue to run even when the compressor is off. This is normal and allows the unit to circulate air
and operate more efficiently
7) Water Tank Full — When the water tank is full of water, the unit will automatically shut off, make a beeping
noise, and the water Tank Full Indicator will light up. The dehumidifier will not function until the water tank is
emptied and placed back inside the unit. The water tank should be cleaned every few weeks to prevent the
growth of mould, mildew and bacteria. Use a mild detergent to clean the water tank. Once clean, completely
dry the water tank and place it back inside the dehumidifier.
Attention:
Before emptying the water tank.
Open the corner of the tank cover and fix it into unit to empty the water. After emptying the water, replace the
cover and fix it back into unit.
NOTE: Hold water tank with both hands when emptying.
NOTE: When the water tank is full or removed from the machine, the compressor will turn off, but the fan will
continue to run for a few minutes. This is completely normal. The dehumidifier will not be removing moisture from
the air at this time.
NOTE: When removing moisture from the air, the dehumidifier will exhaust warm air from top.
NOTE: Do not place a full water tank on the floor, because the bottom is uneven.
8) Defrost Indicator - When the defrost indicator light is on, that means the unit is running the defrost program.
When the temperature of the room is too low, there will be frost on the heat- exchanger, and the unit will auto
run the defrost program. At that time, the compressor is turned off, and the fan continues to run, until the frost
disappears. When the defrost program has finished, the compressor will turn on again, and the defrost
indicator will turn off. If the indicator is flashing, that means the sensor has failed, please call Customer Service.
9) Continuous drainage
Water can be automatically emptied by attaching a hose to the continuous drainage port in the unit. This will
allow the unit to run continuously (depending on the selected humidity level) without having to empty the
water tank. To drain, simply attach the drainage pipe attached.
—
Place the unit on a level surface.
— Pull out the water tank.
— Push the drainage pipe on the port in the unit.
— Reinstall the water tank back into the unit, make sure the pipe is in the notch of the water tank.