Wacker Neuson RTLx-SC3, Руководство оператора

Страница: 36 / 186

Operation
6.7 SmartControl™ SC-3 Transmitter
36
Operator’s Manual | RTLx-SC3 | 5100061327 | 09/2022 | [en-US]
Ref Component Description
8 Stability light The stability warning light illuminates when the pitch of the roller exceeds 45°. The
machine is equipped with safety switches that shut down the engine during such a
condition.
9 Ignition switch Turning the key switch to the ON (I) position supplies 12VDC power to the machine.
The green power-on indicator illuminates indicating power is on. The key switch has
an automatic shutoff feature that powers off the electronics after one hour of non-en-
gine run time. To reset the machine, turn the key switch o the OFF (O) position and
then back to the ON (I) position.
The machine can be restarted within this 1-hour period if the transmitter is turned off
and then on. The glow plugs will be activated if needed.
All shutdown functions have a fault detection feature where the warning light and red
LED light rings remain on after the machine shuts down, until the fault is corrected,
and the key switch is turned to the OFF (O) position.
All shutdown functions and the air filter restriction circuit have built-in circuitry to de-
tect a possible bad sensor, unplugged sensor, or a cut or damaged wire to the sen-
sor. Whenever any of these sensor faults occur, the corresponding control panel light
will flash on and off.
6.7 SmartControl™ SC-3 Transmitter
• Wireless control
• Line of sight operation
• Control channels: 16
• Clear transmissions into direct sunlight, up to 130,000 LUX
• Maximum range: 20m (65 ft)
• Transmitting time (full charge): 12 hours
• Recharge time (full charge): 2-1/2 hours
• Battery: Ni-MH (nickel metal hydride) battery pack
1
2
2
3
4
5
5
6
5
7
8
9
10
11 12
13
14
Fig. 10: SmartControl SC-3 transmitter