Wacker Neuson RCE, Руководство оператора

Страница: 41 / 56

RCE Troubleshooting
Operator’s manual 41
9 Troubleshooting
Potential faults, their causes and the respective remedies are listed in the
following table.
Malfunction Cause Remedy
Workpiece jammed or slipped. Stop screw is set incorrectly. Adjust the stop screw.
Machine not in operation. Input voltage too high or too
low. Provide correct voltage; if
necessary use an extension
cable with sufficient cross
section.
Power cable interrupted. Check power cable, have it
replaced if defective. *
* Have these tasks carried out by the service department of your Wacker Neuson contact person.
Thrust bolt does not extend. Pressure release screw
released. Tighten the pressure release
screw.
Thrust bolt moves out
incompletely or unevenly. Insufficient hydraulic oil in the
hydraulic oil tank. Check oil level, fill with
hydraulic oil if necessary.
Cold hydraulic oil. Warm up machine for approx.
1 minute.
Thrust bolt does not move back
completely. Dirt and cutting residue in the
cutting head. Clean cutting head.
Hydraulic oil is leaking out. Sealing ring on the oil filler neck
is damaged. Check sealing ring, change if
necessary.
Leak on the hydraulic cylinder,
hydraulic oil tank or screwed
connections. Have the machine repaired. *