Wacker Neuson RC50, Инструкция по эксплуатации

Страница: 56 / 222

Operation
Loading and transporting
56 BA RC50_RC70 en 00
3.02 Loading and transporting
N O T E
Observe all regulations when loading and transporting the
machine to and from its place of use!
Regulations and Provisions
When loading rollers onto trucks, trailers or semitrailers, it is essential
to secure the machine properly on the carrying vehicle. The duty for
tie-down on street vehicles arises from StVO § 22, StVO § 23, StVZO
§ 30, StVZO § 31, HGB § 412 as well as from VDI guideline 2700 or
other national requirements. Loading and transporting the machine
requires sufficient knowledge about the loading of vehicles and their
behavior under load. The machine may only be loaded by trained loading
personnel. The machine must be fixed or stowed in transport-safe
way to the vehicle by an form-locked or friction-locked manner or by a
combination with friction. The machine must not change its position on
the vehicle during normal traffic loads. Typical transport stresses also
include emergency braking, evasive manoeuvres and unevenness of the
road. If it is impossible to secure the machine properly onto the vehicle,
or if the loading vehicle shows visible defects which do not ensure safe
transport, loading must not be performed. This condition or requirement
also applies to too little or damaged lashing tackle.
The transport company involved is always responsible for the safe
transport of the machine and accessories.
Loading instructions
When loading please observe the following instructions:
■
Adhere to section Transport as specified in the safety instructions.
■
Observe weight and dimensions ( "Technical data", page 170 sqq.).
■
Observe the legally required maximum height.
■
Only use approved gantries or planks that are provided with an
antiskid coating.
■
Never drive with metal on metal.
■
Gantries, planks and loading areas must be swept clean and free of
grease, dirt and ice etc.
■
Clean roller drums and tyres prior to driving on the gantries.
■
Please ensure a friction factor is µ ≥ 0.6 , e.g. by use of anti-slide
mats.
■
In machines having an all-wheel lock, this lock needs to be set to on
before driving on any ramp or uphill slope.
■
Slowly drive the machine up/down with the speed set to 2/3 and the
drive lever at the 1/4 position.
■
Either remove every loose or movable part in or at the machine, or
secure such parts separately.
■
Lower attachments.
■
In case of rollers with articulated steering, the safety strut must
always be activated for transport.
■
Remove wedges and lashing devices completely before unloading.
Unblock steering system by unblocking the safety strut.