Wacker Neuson PT Series, Руководство по обслуживанию

Страница: 27 / 38

Suction and Discharge Flange
Removal and Installation
NOTE
All suction and discharge flanges are removed the same
way. PT4 is shown.
See Figure 2-6 .
!
WARNING
High temperatures and/or pressures may be
caused during priming or operation. If high
temperatures and/or pressure conditions exist,
do not open any plugs or hoses. Failure to
comply may result in injury or death to
personnel.
NOTE
Both discharge and suction flanges are removed the
same way. The discharge flange is shown.
1. Support pump securely. (See
"
Support Pump Securely " on page 7 .)
Figure 2-6: Discharge Flange Removal and
Installation
2. Remove screws (2) securing discharge flange (1) to
pump (3). Remove discharge flange (1) from pump
(3).
Installation Notes
• Install discharge flange by reversing the order of
removal.
• Ensure discharge flange seal is undamaged prior
to installation.
• Torque discharge flange mounting screws to 7.4
lb-ft (10 N•m).
Spark Plug Inspection
Inspection
!
WARNING
Prolonged contact with lubricating oil may
cause skin rash. Remove saturated clothing
immediately and thoroughly wash skin that
comes in contact with lubricating oil. Failure to
comply may result in injury or death to
personnel.
1. Support pump securely. (See
"
Support Pump Securely " on page 7 .)
2. Remove spark plug.
3. Using a clean cloth, remove any fuel and dirt from
spark plug.
4. Using apropriate tool, adjust spark plug gap to
0.024 - 0.028 in. (0.6 - 0.7 mm) gap.
5. Install spark plug.
6. Attempt to start pump.
7. If pump does not start, replace spark plug.
MAINTENANCE
2
5100048604 (12-18) 2-7