Wacker Neuson PG1, Руководство оператора

Страница: 19 / 44

wc_tx003931gb_FM10.fm
19
PG1 Operation
3.6 Positioning and Preparing the Machine for Operation
Pre-operation
setup Perform the procedure below to position and prepare the machine for operation.
1. Position the pump as near to the water as possible, on a firm, flat surface. Keep
the pump level.
Connect the
suction hose 2. Connect the suction hose (a) to the suction port (b).
■
Suction hoses must be rigid enough not to collapse.
■
At least one hose clamp is recommended for connecting the suction hose to
the suction port.
Connect the
strainer 3. Connect the strainer (c) to the suction hose.
■
Always use a strainer on the end of the suction hose to prevent pulling in
debris which could clog the pump or jam the impeller.
This procedure continues on the next page.
WARNING
Personal injury hazard. Failure to follow the listed procedures may cause injury to
personnel or damage to the machine.
►
All persons setting up the machine must be fully trained on the installation of the
machine.
wc_gr012477
d
a
b
c
d
e
f
WARNING
Personal injury hazard. A loose connection between the suction hose and the
suction port can result in personal injury should the suction hose break loose while
the pump is operating.
►
Only operate the machine when the suction hose is securely fastened to the
suction port.