HI 110 / 200 / 300
Operation
ghi_tx001447gb.fm
21
4.2
Installing the Wheels and Handle
Overview
The axle, wheels, handle, and stand are shipped loose with the machine and must
be assembled before operation.
There are pre-drilled holes for all of the components to be assembled. Bolts,
washers, and nuts are provided.
Installing the
axle and
wheels
Follow the procedure below to install the axle and wheels.
1. Lift the machine using appropriate lifting gear.
2. Attach the two axle mounting brackets
(a)
to the sides of the fuel tank.
3. Insert the ends of the axle
(b)
through the axle mounting brackets.
4. Place a wheel
(c)
and flat washer
(d)
on each end of the axle as shown.
5. Insert hitch pins
(e)
into the holes at each end of the axle to secure the wheels.
A
Atttaching the
handle and
stand
6. Align the holes in the handle
(f)
and stand
(g)
with the holes on the fuel tank
flange as shown.
7. Attach the handle and base support with bolts, washers, and nuts.
Result
The machine has now been assembled. Lower the machine and proceed.
WARNING
Crushing hazard.
f
Refer to chapter
Lifting the Machine
for instructions on proper lifting techniques.
wc_gr007779
e
d
c
a
b
f
g
