8 Operation and use
33
100_0202_op_0011.fm
Start engine
1. Directly aim remote control towards a receiver unit.
2. Briefly press start button of the remote control – the motor will start automatically. When the receiving
units flash yellow, the machine is ready.
Machine with Compatec – compaction display (optional)
1. During the first few seconds after starting the machine, a light progress bar appears on Compatec –
compaction display.
2. LEDs light up starting from left to right.
3. All LEDs will briefly light up again at reduced brightness.
4. The sensor is thus successfully tested and Compatec – compaction display is ready for operation.
8.4
Operation
In accordance with the intended purpose, the operator should stand behind the machine.
Guide and steer machine using the control handle.
Control machine with remote control.
Item
Designation
1
Engine start button
NOTE
The starting process can take up to 2 minutes. As long as the receiving units light red, the
automatic startup will run. Depending on the operating temperature of the engine, the glow
plugs are optionally preheated and warmed up.
Item
Designation
Item
Designation
1
Compatec – compaction display
2
LEDs/light progress bar
NOTE
If all LEDs light up, the system is fault-free. The LEDs will then switch off one after the
other.
NOTE
If all LEDs permanently light after initialization, the sensor has not been successfully
tested; see troubleshooting chapter.
1
1
2
