Wacker Neuson BTS 1030, Руководство оператора

Страница: 14 / 62

T00823GB
12
- Switch off the engine before inspecting the V-belt
tension or tightening it, replacing the cutting
wheel, repositioning the cutter attachment (side or
middle position) or eliminating faults (14).
- Turn off the engine immediately and check the disc if
you hear or feel any change in cutting behaviour.
- Turn off the Power Cut when taking a break or
stopping work (14). Place the unit in such a way that
the disc is not touching anything and cannot endanger
anyone.
- Do not put the overheated Power Cut in dry grass or
on any inflammable objects. The muffler is very hot
(danger of fire).
- IMPORTANT: After wet cutting, first turn off the water
feed and then let the disc run at least 30 seconds, to
fling off the remaining water and prevent corrosion.
Kickback and lock-in
- When working with the Power Cut there is a danger of
kickback and lock-in.
- Kickback occurs when the top of the cutting disc is
used for cutting (15).
- This causes the Power Cut to be thrown back toward
the user with great force and out of control. Risk of
injury!
To prevent kickback, observe the following:
- Never cut with the section of the cutting disc shown in
figure 15.
Be especially careful when reinserting the disc
into cuts that have already been started!
- Lock-in occurs when the cut narrows (crack, or
workpiece under stress).
- This causes the Power Cut to suddenly jump forward,
out of control and with great force. Risk of injury!
To prevent lock-in, observe the following:
- When reinserting the disc into previous cuts, have the
Power Cut running at top speed. Always cut at top
speed.
- Always support the workpiece so that the cut is under
tension (16), so that the cut does not press together
and jam the cutting disc as it proceeds through the
material.
- When starting a cut, apply the disc to the workpiece
with care. Do not just shove it into the material.
- Never cut more than one piece at a time! When
cutting, make sure that no other workpiece comes into
contact.
*
Maintenance
*
Refuelling
*
Changing cutoff
discs
*
Repositioning the
cutting attachment
*
Stopping work
*
Transport
*
Putting out of
function
14
15
16