Using Power Switch
This process can be used when it is inconvenient to use
one of the other processes.
NOTE: You must use a switch that cuts power to the fan
receiver for this process to work.
This will reset all fans connected to the switch being used.
1. Turn off power at power switch for 3 seconds.
2. Turn on power for 6 seconds. Turn off power.
3. Turn on power. In approximately 6 seconds the receiver
will beep. When the receiver beeps turn off power.
Repeat step 3 four additional times. On the fourth
repetition the fan will beep three times indicating the
fan has performed a factory reset.
NOTE: This will remove remote control(s) and wall control(s)
connections.
Using Receiver Button
1. Power down the receiver and within 3
minutes of turning the power back on,
press and hold the reset button on the
receiver until the receiver beeps.
2. Power cycle the circuit to complete the
process.
NOTE: This will remove remote control(s)
and wall control(s) connections.
FIG.7
5
Factory Reset
Using remote control
NOTE: This will remove remote
control(s) and wall control(s) connec-
tions.
1. Press and hold the
,
and buttons for 10 seconds.
2. The LED will blink red and
return to solid red, and the
receiver will beep to indicate
that the factory reset is suc-
cessful.
CAUTION: The user is cautioned that changes or modifi cations
not expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of
the following measures:
•
Reorient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit diff erent
from that to which the receiver is connected.
•
Consult the dealer or an experienced radio/TV technician
for help.
FCC Supplier’s Declaration of Conformity
Brand name: WAC
Model number:
RC20-WT
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause
undesired operation.
WAC LIGHTING CO.
44 Harbor Park Drive, Port Washington, NY 11050
Tel: 1-800-526-2588
Rules and Regulations
Unpairing
NOTE: Unpairing must be completed
within 3 minutes of turning the power
on to the fan receiver.
1. When you re-engage power to the
fans you want to unpair, press and
hold the
and
buttons
for 4 seconds.
2. The LED will blink green, and the
receiver willbeep to indicate that
unpairing is successful.
4
FIG.5
FIG.6
Press and Hold
Press and Hold
“The bluetooth ® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use
of such marks by Wangs Alliance Corporation is under
license. Other trademarks and trade names are those
of their respective owners.”