2
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program.
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
Fig.1
6 5/8”
3 7/8”
1 3/8”
1 3/4”
Back Plate Dimensions
Wire Connector
Junction Box
Screw
Driver
Rubber Gasket
Mounting Backplate
Ground Wire
Junction Box
White Wire
Black Wire
Mounting Screw
A1
B1
D1
C1
PREPARATION
1. Shut off the power at the circuit breaker and remove existing fixture, including the mounting hardware.
2. Carefully unpack your new fixture and lay out all the parts on a clear area. Be careful not to lose any small parts necessary for installation.
MOUNTING THE FIXTURE (FIG. 1)
3. Remove the mounting screw (C1) and rubber gasket (D1) from the fixture.
4. Secure the mounting plate to the junction box using the junction box screw (B1).
The side of the mounting plate marked “GND” must face out.
CONNECTING THE WIRE (FIG. 2)
5. Connect the driver input wire to junction box wires as shown in
Fig. 2
, making sure that all wire connectors (A1) are secured. If your outlet
box has a green or bare copper ground wire, connect the fixture’s ground wire to it. Otherwise, connect the fixture’s ground wire directly to
the back plate using the green screw provided. After wires are connected, tuck them carefully inside the junction box.
MOUNTING THE FIXTURE (FIG. 1)
6. Place the fixture over the mounting plate, secure it with the mounting screw (C1) and rubber gasket (D1).
7. To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of fixture back plate where it meets the wall. Leave a space at the bottom to allow moisture to escape Fig.3.
Fixture Wires
Black or
Smooth
Fixture Wires
White or
Ribbed
Fixture Wires
Bare wire
(Ground)
House Wires
Black
(Hot)
House Wires
White
(Neutral)
House Wires
Green or Bare Copper
(Ground)
Fig. 2
Junction Box
Caulking
Fig.3 Sealing
INSTALLATION INSTRUCTION
37612 - dweLED™ Wall Sconce
WS-W37612
