WAC Lighting
www.waclighting.com
Phone (800) 526.2588 • Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone (516) 515.5000 • Fax (516) 515.5050
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone (800) 526.2588 • Fax (800) 526.2585
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MAy, 2014
INSTALLATION INSTRUCTION
Premium Xenon Light Bars
BA-LIX
WIRING OF MULTIPLE UNITS:
In addition to hard wiring, components are provided to allow fixtures to be joined through surface wiring.
Note: The total wattage of all connected fixtures should not exceed 700 watts.
END TO END CONNECTION ( I-CONNECTOR INCLUDED ):
The “I” connector allows two fixtures to butted end to end.
1. Pry out the plastic covers concealing the female connection ports at the end of the fixtures.
2. The “I” connector will only fit in the correct orientation.
3. Insert one end of the “I” connector into the fixture. Slide the next fixture to abut the original.
4. Secure position by mounting fixtures to the surface.
INTERCONNECTING FIXTURES WITH JUMPER WIRE (SOLD SEPARATELY):
A surface mount jumper wire allows multiple units to be linked through surface wiring (see diagram below).
1. Pry out the plastic covers concealing the female connection ports at the end of the fixtures.
2. Jumper wire ends will only fit in the correct orientation.
3. Insert the ends of the connectors into each fixture.
4. Jumper wires use metal strain relief cover brackets. Slide the cover bracket over the connector. Position bracket and fixture
holes and secure with screw provided.
5. Wrap excess wire with nylon wire ties.
CORD AND PLUG USE ( SOLD SEPARATELY ):
Install the connector end of plug in line cord as described above (using a Jumper wire).
TO RE-LAMP:
•
Turn off fixture and allow it to cool before replacing lamp.
•
For use with Xenon (not tungsten halogen) G8 bi-pin 110 Volt 25 Watt lamps.
1. Remove the two screws securing the cover plate.
2. Lift the cover plate to expose the lamps.
3. Withdraw the lamp by pulling away from the ceramic socket base.
4. Re-lamping is the reverse procedure.
