WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. MArCh 2, 2016 12:00 PM
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
4
INSTALLATION INSTRUCTION
Accent
5011 / 5012
Step 6: Beam Angle Adjustment:
18. Note the four pre-determined beam angles on the beam angle
changing dial.
19. Use the provided Hex Key to sightly loosen the screw.
Do not remove screw from the fixture.
CAUTION:
the set screw should either be inset or flushed with
the surface of the fixture. Do not extrude out and removed from
the fixture at all times. It should only be taken out for fixture
servicing. Consult factory for service instruction.
20. Rotate the dial until the arrow is aligned with the desired
beam angle. This beam angle may either be one of the
pre-determined ones or any number in between.
21. Tighten the set screw that is located on the beam angle dial to
lock the dial in place.
Step 7: Shroud Adjustment
22. Loosen the thumb screw on the shroud.
23. Rotate the shroud until it is in the desired position to properly
cut off glare.
24. Retighten the thumb screw to lock the shroud in place.
Beam Angle Dial
Hex Key
Shroud
Thumbscrew
10
25
40
60