Operation & Maintenance Instruction
August, 2003
Page 5 of 24
4225-50, S.6
WARNING:
The following statements of warning apply,
all or in part, wherever the symbol
appears in the
maintenance procedures. Failure to observe these precautions
may result in serious injury to those performing the work
and/or bystanders.
Portions weigh in excess of 30 pounds. Use care
when lifting and hauling portions to preclude injury.
Due to the possibility of exhausting air, and high
decibel levels of noise associated with it, from the
device during testing, it is recommended that sufficient
hearing and eye protection be used. This is intended
to minimize the possibilities of hearing and eye injury
to the operator or persons near the test rack.
The use of an air jet, which must be less than 30
p.s.i.g., to blow parts clean or to blow them dry after
being cleaned with a solvent will cause particles of
dirt and/or droplets of the cleaning solvent to be
airborne. Wire brushing may also cause particles of
dirt, rust and scale to become airborne. These
conditions may cause skin and/or eye irritation.
When using an air jet, do not direct it toward
another person. Improper use of air jet could result in
bodily injury.
Personal eye protection must be worn when
performing any work on this device or its component
parts to avoid any possible injury to the eyes.
The use of solvents and lubricants can involve health
and/or safety hazards. The manufacturers of the solvents
and lubricants should be contacted for safety data (such
as OSHA Form OSHA-20 or its equivalent). The
recommended precautions and procedures of the
manufacturers should be followed.
When performing any test or work on devices or
equipment while they are on the vehicle (on car test
etc.) special precautions must be taken to ensure that
vehicle movement will not occur which could result in
injury to personnel and/or damage to equipment.
Figure 5 - ABDX-SS Control Valve, Part No. 664742
8
A
B
3
4
5
6
10
9
11
7
C
12
2
1
8
