33
The lathe should be lubricated every 8 operating hours according to the lubricating schedule (2.1).
Lubricating points 3 (bed guide), 4 (dove-tail guide cross slide), 5 (dove-tail guide top slide) and 7
(tailstock barrel) with the help of an oil can and a standard lubricating oil, moving the saddle and
the barrel backwards and forwards while doing so.
All other lubricating points are lubricated at the designated lubricating nipples with a grease gun
andstandard roller bearing grease.
6.4
Guidelines for the periodical maintenance of the machine
Daily
The lubricating points in compliance with lubricating schedule 2.1
(every 8 operating hours
)
Clean the machine and guides.
Every 3 months
Check the tension of the Poly-V and pulley and tighten as
(every 500-600
necessary.
operating hours)
Check the play in the guideways and leadscrews and adjust.
Check the bearing heat in the main spindle and electric motor.
7. Safety
instructions
1. The feed line for the motor may only be connected to a shock-proof socket or juction box.
(Have the socket or junction box checked by an electrician beforehand; protection against chil-
dren being able to put into operation).
2. The socket or junction box must be close enough to the equipment, that the current-carrying
cable is subjected to no tensile strain whatsoever.
3. When maintenance or cleaning work is being done, the machine must be shutdown and the
mains plug pulled out.
4.
Do not brake workpieces or chuck by hand or any other objects.
5.
Wear safety goggles when working the machine.
6. Do not remove the chips with the hand. Use corresponding aids (hand brush, hook, paint
brush).
7.
Always keep the protective hood on the driving mechanism closed.
8.
The turning tools must be firmly tightened at the correct height and as short as possible.
9.
The turning tools must never be exchanged when the machine is running.
10.
Never leave the clamping chuck key in (even when not in operation).
11. Observe the bearing distance of the turning chuck. (turning jaws max. 40mm
∅
, drilling jaws
max. 100mm
∅
).
12.
Never take measurements on workpieces being turned
(danger of accidents and damage
to the measuring gauges).
7. Safety
instructions
13. Do not wear loose items of clothing (ties, shirt sleeves, jewellery etc.).
Содержание CC-D4000 E
