WABCO TP2205, Руководство по установке

Страница: 15 / 48

15
Installation – TRAILERCAST with Battery Position
6 Installation – TRAILERCAST with Battery Position
6.1 General Recommendations
„
When installing TRAILERCAST with Battery, keep the area around the antennas away from metal or
other obstructions as much as possible to avoid signal disturbance.
„
As ZF cannot document all different trailer configurations, we recommend validating the installation of
the unit with a ZF technician before deploying on a large scale.
„
Verify the installation with an external power source connected to the TRAILERCAST with Battery unit.
„
To obtain a full battery capacity, connect the TRAILERCAST with Battery unit to an external power
source for 4 hours.
„
Make sure that the unit will not be continuously exposed to direct sunlight.
„
Make sure that the label of the unit is always visible.
„
The installation technician remains responsible at all times for the correct installation and connection of
the hardware unit.
„
Always verify that sufficient GPS coverage is guaranteed during installation, and a good GPS position
has been received via https://install.us.wabco-fleet.com/search/?device=trailercast . Check this for every
installation.
6.2 Preferred Installation (Standard Trailer with Fixed Trailer Bed)
„
In case the installation includes a Tire Pressure Monitoring System (TPMS) system (connecting to the
internal sensors), an installation bracket MUST be used to fix the TRAILERCAST with Battery.
„
The unit must be installed below the trailer bed with the front of the TRAILERCAST with Battery unit
directed to the ground.
„
Make sure that the front of the unit has a clear view to the ground (not obstructed by other components).
„
Keep the sides of the unit at a minimum distance of 20 cm from obstacles.
„
Always verify that sufficient GPS coverage is guaranteed and a good GPS position has been received
using https://install.us.wabco-fleet.com/search/?device=trailercast (Section 14 Checking the Installation,
page 38).