8
Installation
3. Install the new ECU/modulator assembly and bracket provided in the kit onto the vehicle. Figure 3
shows the installation of the new kit on the vehicle. Use the existing mounting hardware. Tighten the
four mounting screws to OEM torque speci
fi
cation. Figure 1 and Figure 4 show the replacement part.
Please observe the mounting holes on the bracket
fl
ange are clocked at 7 degrees.
The new ECU/modulator assembly and bracket are designed with a 7-degree horizontal tilt
when installed into the vehicle. The motor axis must make an angle of between 5 and 30
degrees with the vehicle’s horizontal plane, and the back of the motor must point upward.
Figure 4 shows the required installation orientation of the repair unit relative to the horizontal
plane of the vehicle.
Fig. 3
4008853b
Fig. 4
TILTED 7° RELATIVE
TO VEHICLE FRAME
7°
4008666b
4. Remove and scrap the plastic plugs from the hydraulic ports of the new ECU/modulator assembly.
Figure 5.
Fig. 5
4008664b
PLASTIC
PLUGS
