NOTE:
THESE BACKUP BATTERIES WILL ALLOW THE BED TO BE LOWERED IF A POWER OUTAGE
OCCURS. IT IS RECOMMENDED NOT TO DO ANYTHING EXCEPT TO LOWER THE BED AS THE BATTERY
BACKUP WILL NOT ELEVATE THE BED SECTIONS.
HEAD AND FEET SECTIONS CAN BE LOWERED BY
PRESSING “HEAD DOWN” OR “FOOT DOWN” ON REMOTE CONTROL.
It is recommended to replace the two 9 volt batteries every 12 months or after every emergency lowering use. It is important
to always have extra 9 volt batteries in case extra energy is needed during a power outage.
Base Assembly
Page 3
Step 5
Remove the twist ties and
release the DC cord.
Step 7
Insert the AC cord into the Pow
-
er Supply and lock it using the
clip. NOTE: DO NOT PLUG
BASE INTO THE POWER
OUTLET YET.
Step 6
Plug the two 9 volt batteries
(included) in the compartment of
the Power Supply and insert the
cover to close.*
Step 1
For safety reasons, It is highly recommended to use two people for lifting and the installation of this product. Before assembly,
place the unit in the final installation location to make the assembly process easier. The unit should always be in a flat surface
when opening and placed top side down on the floor according to the box instructions. Remove the top section of the box.
Step 4
Screw in the provided legs (6) in each corner and center of the base rotating clockwise
until tight.
DO NOT OVER TIGHTEN THE LEGS.
Step 2
Carefully lift top
section of the base
from the opposite
side of the hinges
to unfold.
Step 3
Remove any
accesory boxes/
bags and untie the
mattress retainer,
which is held with
orange plastic ties.
