www.prolight.co.uk
RM 05 MKII
User Manual
6
Operating instructions
Operation:
•
Carefully, lift the antenna into the vertical position and extend fully.
•
Connect the included power supply to a suitable 240V AC~ 50Hz mains voltage outlet and plug the
DC connector into the DC Power Input on the rear panel of the receiver (9-15V DC, 300mA minimum)
•
Using the supplied audio cable, connect the Audio Out on the rear panel of the receiver to the
mixer’s audio line input.
•
Switch on the power, checking the red power LED illuminates.
•
Open the battery compartment on the transmitter (Beltpack – slide downwards away from the belt clip.
Handheld - unscrew the lower portion). Install the appropriate batteries into the transmitter, taking care
to observe the orientation and polarity. Only use high quality, alkaline type batteries. Refit the battery
compartment cover carefully.
•
Switch on the transmitter, during switch on the battery light on the transmitter should come on.
If the transmitter is low on battery the green light illuminates permanently and the battery will require
replacement.
•
Adjust the volume on the front panel of the receiver and if required also adjust the
volume on the belt pack.
NOTE:
The RM 05 MKII system is shipped with two transmitters (one handheld and one beltpack). The receiver in this system
may only be used with one transmitter at any one time. If the user attempts to power on, and use two transmitters with
one receiver the system will malfunction and not operate correctly as one transmitter will cut out the RF Radio signal to
the second transmitter.
