Installation on a Speaker Stand
The speaker system may only be installed on a speaker
stand if the original speaker system is equipped with an
appropriate stand adaptor.
Stands or satellite systems must only be installed on a plane
area with a maximum inclination angle of 5˚.
CAUTION:
Speaker systems installed under the influence of
horizontal forces, e.g. wind, can be impaired. This is why
additional safety measures like attaching ballast weights
have to be taken.
If inclined tension cables or prolonged outriggers are used.
the area of danger has to marked or blocked.
Before lifting or lowering the telescopic tubes, you must
always block a safety area around the stand or satellite
system. This safety area must have a diameter of 1.5 times
the maximum height.
Lifted telescopic tubes always have to be secured with a
secondary securing attachment.
The total weight of the installation (total weight of system
including individual parts) must never exceed the maximum
load of the installation area.
Unintended movement of the load has to be avoided - also in
case of fire!
Loosen the fixing screws of the legs, pull the legs out until the
cross struts are at a 90˚ angle to the legs. Tighten the fixing
screws of the legs.
8
Installation Of The Speaker System
CAUTION:
The loads have to be installed in a balanced way.
CAUTION:
The carrying capacity of the stand or speaker stand must never be exceeded.
