Vytronix NC22V, Инструкция по эксплуатации

Страница: 13 / 16

TROUBLESHOOTING
The appliance will not power on:
This may be caused by a flat battery. This can occur if the appliance has been used or stored for
an extended period. Connect the vacuum to the charger and allow for a full charging cycle to
complete. If the battery is flat, one single blue light will flash to indicate this.
The vacuum stopped suddenly:
This will occur if the safety cut-out device has been activated. This device is designed to prevent
your appliance from overheating. Ensure the vacuum is turned off, disconnect all accessories and
leave to cool down for at least half an hour before attempting to operate again.
Empty the dust container and clean or replace the filter.
The suction of the vacuum has reduced:
Turn the vacuum off. Disconnect the floor head, extension wand and any accessories. Check for
and remove any blockages from the dustbin filter, air vent, extension wand, floor head and
accessories. If filter is heavily soiled, clean as per filter maintenance instructions.
Motorised floor head is not rotating:
This tends to occur when there are too many fibres wrapped around the brush roll restricting
movement or if something has become lodged or jammed within the floor head / brush roll. Consult
the cleaning the brush section of this manual for instructions on how to appropriately clean the
brush roll. Remove the brush and check the blue charging lights do not flash.
The blue charging indicator lights do not flash:
There may be no power reaching the vacuum from the charger.
Ensure that power is being supplied to the mains socket and that the charger is turned on. Ensure
the charging cable is securely connected to the vacuum
Ensure the mains socket is switched off before checking the charging cable itself. Do not attempt
to use if the cable is split, frayed or otherwise damaged - instead, contact the manufacturer.
The application time of the vacuum is less than it used to be:
Ensure the battery has completed a full charging cycle. An insufficient charging cycle will result in
reduced application time.
There may be reduced energy discharge in the battery. This is normal and gradually occurs in all
batteries over time.
SPECIFICATIONS
Input Voltage 100-240V 50/60Hz
Operating Voltage 22.2V
Operating Power 200W
Floor Brush Power 12W
Battery Capacity 2200mAh
Charging Time 3-4 hours
Dust Cup Capacity 0.5L
Product size 1100*235*220mm
Net Weight 1.6kgs