How to use
•
For optimal performance, your ePen should be fully
charged before first use. Please refer to the following
page for more information on how to charge.
•
Open the device by detaching the ePen top from the
ePen battery.
•
Remove the silicone cover on the ePen cap before
screwing it onto the ePen battery. Be careful not to
over-tighten.
•
Once the ePen cap is securely attached to the ePen
battery, place the ePen top back over the ePen cap
and push gently to secure.
•
To switch on your ePen, rapidly click the double arrow
button or single arrow button three times. The
ePen will confirm that it is switched on by illuminating
the LED for three seconds.
•
To begin your vaping experience, press one of the two
buttons and hold it down whilst inhaling. The LED will
illuminate white.
•
This device is equipped with two voltage settings.
Press and hold the double arrow button for more
vapour, press and hold the single arrow for less
vapour.
•
If you press both buttons at the same time, your ePen
will not work.
•
Only use Vype ePen caps with the Vype ePen device.
•
The ePen can be locked by rapidly clicking on the
double arrow button or single arrow button three
times. The ePen will confirm that it has switched off
by flashing the LED three times.
•
If the ePen remains unused for 10 minutes, it will
automatically switch off and will need to be switched
back on to use.
•
To confirm whether your ePen is on or off, press either
of the buttons once. If the ePen is on, the LED will
illuminate for three seconds. If the ePen is off the LED
will not illuminate.
When to change your ePen cap
It’s time to change your ePen cap when:
•
Your ePen stops producing vapour.
•
You notice a deterioration in the taste or quality
of the vapour.
If your ePen stops producing vapour and the cap is not
yet empty, check your battery is fully charged.
Battery status indicators on your Vype ePen
When the ePen is turned on or off, or when either button is
pressed once when the ePen is on, the colour of the LED
will indicate the battery level:
•
Green: Your battery is charged.
•
Amber: Your battery is running low.
•
Red: You need to recharge your battery.
•
Flashing Red: Your ePen is out of charge and will turn off.
Your ePen battery may run out of charge before the ePen
cap is finished so don’t automatically discard the cap when
charging the battery as there may still be e-liquid in it.
How to charge your Vype ePen
•
To charge your ePen, attach the supplied USB charging
cable to the micro USB port on the base of the ePen.
•
Connect the other end of the USB charging cable to the
USB port of a computer.
•
When charging, the LED on the ePen will pulsate.
•
When the LED shows continuous green, the ePen
is fully charged and the USB charging cable should
be disconnected.
•
It should take no longer than 2 hours to fully charge your
ePen battery.
•
If your ePen LED starts to flash red rapidly whilst charging,
please disconnect and contact the customer care line.
•
You can also charge your ePen using a Vype USB
car charger or Vype wall plug, which are available
at govype.com.
This Vype ePen starter kit contains:
1 x ePen device
1 x Micro USB charging cable
2 x ePen caps: 1 x Blended Tobacco and
1 x Crisp Mint – 18mg/ml nicotine each
1 x User guide
Visit our website
govype.com
to discover our flavour range.
1 x ePen device
ePen top
ePen battery
USB port
