Vynco VMEV, Инструкция по установке

Страница: 4 / 12

INSTALLATION INSTRUCTION
VYNCO.CO.NZ
VMEV
The VMEV is designed to be installed
in a hollow wall cavity, resulting in a slim
flush finish.
MOUNTING INSTRUCTIONS
1. Select a suitable mounting position on an
indoor wall. The position must be at least
800mm above the floor or ground and
300mm from any wall or corner.
2. Frame the installation location to suit
the dimensions of the base box. Ideal
framing will allow the secure fixing
of the base box on a minimum of
two sides, leaving the top open for
wiring installation.
2
3. Fold out the 4x side tabs of the base box.
Insert the base box into the pre-prepared
framing. Ensure the arrow is orientated
upwards. The side tabs will place the box
at the correct height on the framing to
align with standard 10mm wall linings.
4. Securely fasten the base box to the
framing through the internal
mounting slots.
5. Finish wall lining around the base box.
A standard 10mm wall lining should
finish flush with the front sides of the
base box leaving an open space for an
EV charger to be installed in.
NOTE: Wall lining can be installed after
wiring is complete, prior to the door and
cover being installed.
310.00
FINISH:
MATERIAL:
REVISION:
DESCRIPTION:
SHEET 1 OF 1 A3 SIZE
APPROVED BY:
PART No:
388 Tuam St
Christchurch
New Zealand
P: 03 379 9283
W: vynco.co.nz
UNLESS OTHERWISE STATED ALL DIMENSIONS ARE IN MILLIMETRES
ALL CRITICAL TOLERANCES SPECIFIED IN DRAWING
NON SPECIFIED TOLERANCES:
LINEAR: 0.0 ±0.5 0.00 ±0.1 ANGULAR: ±0.5°
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF VYNCO INDUSTRIES
(N.Z.) LTD. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION
OF VYNCO INDUSTRIES (N.Z.) LTD IS PROHIBITED.
DRAWN BY:
DRAWN DATE:
CHANGE BY:
CHANGE DATE:
APPROVED DATE:
- - - 24678-000
BOX AHEAD EV CHARGER
-
-
soppitb
24/08/2021
-
-
24/08/2021
XXXX
DRAWING NOT TO SCALE