INSTALLATION INSTRUCTIONS
VYNCO.CO.NZ
INSTALLATION PROCEDURE
STEP 1
Loosen the 4 x M6 cover screws holding on the
cover and remove the cover by sliding it off the fan
base assembly.
STEP 2
Make a hole cut-out on the mounting surface that
can accommodate spigot and electrical supply cable.
STEP 3
From the above wiring diagram, wire fan
and capacitor inside to the terminal box.
STEP 4
Securely seal the ducting to the spigot.
STEP 5
Mount the fan base assembly to the wall or soffit.
Ensure terminal box and duct are placed inside
the cut-out.
STEP 6
Ensure the fan is level before tightening screws.
STEP 7
Reinstall cover to the fan base assembly by securing
4 x M6 cover screws on both sides.
WIRING DIAGRAM
MOTOR
E
L
N
CAPACITOR
(BLUE)
(YELLOW/GREEN)
(BLACK)
(BROWN)
(RED)
(RED)
REVISIONS
REVISION
DATE
01
03/12/2020
NEW WIRING LAYOUT CREATED TO IMPROVE INSTRUCTIONS
FINISH:
MATERIAL:
REVISION:
DESCRIPTION:
SHEET 1 OF 1
A3
SIZE
APPROVED BY:
PART No:
388 Tuam St
Christchurch
New Zealand
P:
03 379 9283
W:
vynco.co.nz
UNLESS OTHERWISE STATED ALL DIMENSIONS ARE IN MILLIMETRES
ALL CRITICAL TOLERANCES SPECIFIED IN DRAWING
NON SPECIFIED TOLERANCES:
LINEAR: 0.0 ±0.5 0.00 ±0.1 ANGULAR: ±0.5°
THE INFORMATION CONTAINED IN THIS DRAWING IS THE SOLE PROPERTY OF VYNCO INDUSTRIES
(N.Z.) LTD. ANY REPRODUCTION IN PART OR AS A WHOLE WITHOUT THE WRITTEN PERMISSION
OF VYNCO INDUSTRIES (N.Z.) LTD IS PROHIBITED.
DRAWN BY:
DRAWN DATE:
CHANGE BY:
CHANGE DATE:
APPROVED DATE:
-
01
DRAFT
VEF2-WIRING LAYOUT
MAGNUM FAN GRILLE WIRING DIAGRAM
sangas
3/12/2020
-
-
3/12/2020
sangas
DRAWING NOT TO SCALE
VEF2B / VEF2W / VEF2G - MAGNUM ARCHITECTURAL EXTERNAL FAN + GRILLE