Vykon JACE-700, Инструкция по установке

Страница: 12 / 36

May 2, 2011 MOUNTING
Physical Mounting
12
Part Number 11694 Rev 1.6 JACE-700 MOUNTING AND WIRING GUIDE
|
Figure 3 and the following procedure provides step-by-step DIN rail mounting
instructions for the controller.
Figure 3 JACE-700 controller and accessory mounting details.
Note
Mount the NPB-PWR-UN power supply first, then the controller, then any
directly attached I/O expansion module.
Procedure 1 To mount on DIN rail
Step 1 Securely install the DIN rail with at least two screws, near the two rail ends.
Step 2 Position the NPB-PWR-UN power supply module on the rail, tilting to
hook DIN rail tabs over one edge of the DIN rail (
Figure 3 ).
Step 3 Use a screwdriver to pry down the plastic locking clip, and push down and
in on the module, to force the locking clip to snap over the other edge of the
DIN rail.
Step 4 Mount the controller onto the DIN rail in the same way, such that its left
6-position end connector faces the NPB-PWR-UN power supply.
Step 5 Slide the two devices together along the DIN rail to connect their 6-position
connectors.
4.1" (104)
5.6"
(142)
3.46"
(88)
11.75" (298)
15.125" (384)
Mounting on
DIN rail
Removing from DIN rail
NPB-PWR-UN
DIN rail
end clip
NPB-PWR-UN
IO-16-485
JACE-700
Secure controller or last
directly attached I/O
module using either
screws or DIN rail end
clip (if end clip does not
interfere with 6-position
end connector).