Vxl Winlinx Lite, Руководство пользователя по оборудованию

Страница: 4 / 27

Winlinx -V8 Thin Client Family Hardware User's Guide
iv
FEDERAL COMMUNICATION COMMISSION (FCC) STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the Instructions, may cause harmful interference to radio
communications, however there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment OFF and ON, the user is encouraged to try
to correct the interference by one or more of the following measures:
a.
Re-orient or relocate the receiving antenna.
b. Increase the separation between the equipment and receiver.
c. connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
d. consult the dealer or an experienced radio / television technician for help.
e. Ensure that all expansion slots (on the back or side of the computer) are covered
with metal retaining brackets, and tightly attached to the computer cabinet.
Each Thin Client is equipped with a FCC compliance label that shows only the FCC
identification number. The full information of the associated label is as follows:
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including
interference that may cause undesired operation.
WARNING
•
Only equipment certified to comply with Class B (computer input/output
devices, terminals, printers etc.) should be attached to this equipment, and
must have shielded interface cables.
•
Any changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate this equipment.
•
This equipment should not be used in electro-medical applications.
•
There are no user serviceable parts inside.
DO NOT disassemble the equipment as this can nullify your warranty
•
DO NOT operate this equipment in corrosive or explosive atmosphere.
•
DO NOT operate this equipment outside specified temperature limits.