9
/
20
Figure 3
•
Open the locking device on the drive head by turning it 60° counter clockwise (e), (Figure 4).
•
Feed the steam pipe in until it stops.
•
Then lock the locking device by turning it clockwise by 60°.
•
The plastic screw nut (f) helps loosen evaporating flask(Figure 4)
-Hold the tight-fitting evaporator piston(e) and turn the plastic screw nut (f) until the evaporating
flask loosen.
Figure 4
Note: Prior to commissioning, hand-tighten the plastic screw nut (f) left-aligned.
•
Installing condenser seal (Figure 5 and Figure 6).
Figure 5
Figure 6
•
Installing condenser (g) (Figure 7 and Figure 8).
-
Load the cap nut (h) and locking spring (i) to condenser in turn.
-
Tighten the cap nut hand-screwed (h). Start the device at 200 rpm for 2 min. Then tighten
