Refrigerated Incubator
4-3
VWR Collection
Section 4
Unpacking and Installation
1. Remove all protective tape from doors and shelves.
2. Clean interior and exterior with warm soap and water. Shipping tape
residue can be removed using isopropyl alcohol.
3. Uncoil line cord from rear of unit. Connect the plug to a power outlet
that complies with the electrical requirements specified on the unit's
label and with proper safety ground connection.
4. Record serial number from unit on front cover of owner/operator
manual.
1. Disconnect unit from power source. On inside of door, directly behind
controller, open snapped conduit and remove controller cable.
2. Remove screw that secures cable clamp holding controller cable, then
replace screw.
3. Remove controller cable from anchors and ties that run along inside
chamber side and back walls.
4. Place 3 provided adhesive-backed mounting anchors at approximately
the same spacing (on opposite side) as existing anchors.
5. While supporting door with one hand, remove screw securing door to
upper hinge, then lift door off bottom hinge.
6. Remove the three screws securing each hinge to chassis.
7. Remove three plug screws covering holes on left side, then install them
in holes on right side.
8. Install hinges on left side using screws removed in Step 6. Position
hinge with door screw on bottom.
9. Position door on hinge, then insert screw previously removed in Step
5.
10. Attach supplied latching duct to inside on door, in line with controller
cable toward opposite side on door from other duct.
11. Route cable using mounting anchors, ties and latching duct.
12. Remove screw on left front of enclosure and install cable clamp with
removed screw.
13. Adjust size of loop in cable where door is hinged to ensure door can
fully open and close without interference.
Installation
(continued)
Door Reversal
(if necessary)
