FOR MORE INFORMATION ON
BLADE SMART GLASSES, VISIT:
vuzix.com | vuzix.eu | vuzix.jp
©Vuzix 2019. This install guide is subject to change.
Please read the safety section of the user’s manual before using this product.
All trademarks belong to respective owners.
447PB0007-0001
BLADE PRESCRIPTION LENS INSTALL GUIDE
INSTALLING RIGHT RETAINER & LENS
Place the Right Retainer with its adhesive
backing face down on a clean surface.
Hold the Installation Tool with the “Right”
side up and position it on the Right Retainer,
pressing firmly until it properly fits.
Still holding the Installation Tool, carefully peel
off the adhesive backing from the Right Retainer.
Holding your Blade Smart Glasses in your other
hand, line up the Installation Tool to fit on the left
side of the frames. Firmly press the Installation
Tool with your thumb for 3–5 seconds.
Carefully remove the Installation tool. The
Retainer is now installed.
To mount your Right prescription lens into the
Retainer, carefully fit it on and snap it into place.
INSTALLING, REMOVING, & REPLACING LENSES
To install new prescription lenses on Blade Smart
Glasses already outfitted with retainers, simply and
carefully fit the lens on to its corresponding retainer
and snap into place.
To remove or replace lenses, hold
the frames in one hand and use
the Lens Removal Tool as shown
to carefully pry each lens from
its retainer.
ADJUSTING THE NOSE BRIDGE
Blade Smart Glasses can be adjusted to comfortably accommodate the addition of
prescription lenses by modifying the frames with the Extended Nose Bridge.
Using a small Phillips-head screwdriver, carefully remove the standard-size nose
bridge from the frames. Insert the extended nose bridge on to the frames and
replace the screw, making sure not to over-tighten.
IMPORTANT NOTE
: Once your lens is mounted, please allow 48 hours for the
Retainer’s adhesive to fully dry before removing the lens. Failure to wait could
allow Retainer to be removed and damage to Blade.
B
C