VUTEC CORPORATION
TEL: (954) 545 9000
FAX: (954) 545 9011
E-MAIL: [email protected]
INSTALLATION INSTRUCTIONS
HOME THEATER SERIES
FIXED FRAME SCREEN MODEL VISION XWF
Identify the frame pieces and lay them on a clean and flat surface with the backsides face up.
Attach the two corner brackets to both ends of the height frames (short length) as shown in Figure 1.
Figure 1
Snug tight the cap screws. Be sure to use the external tooth washers for proper locking.
Connect the width frames with the height frames to form a complete screen frame.
Snug tight the cap screws. Check for squareness and proper joining of the four corners. Make adjustments as
necessary before completely tighten the screws.
Do not attach the screen fabric to the frame yet!
Referring to Figures 2 and 3, install the four mounting brackets to the screen frame.
Determine the location of the screen on the wall. Be sure the screen is level when viewed from the front.
While holding the frame against the wall; mark the location of the two visible holes of each bracket.
Remove the mounting brackets from the frame.
Install the mounting brackets to the wall with all three holes on the bracket.
NOTE
: All brackets must be mounted on wall studs for proper support. If wall studs are not found, suitable
wall anchors (not supplied) should be considered.
