How to install & remove remote controller
How to install:
Every transmitter and receiver is originally matched with a
special identity, and can be re-matched by learning mode
when it doesn’t work properly.
How to operate?
First, switch on the transmitter and receiver separately, and
then connect them with specially made cable with
micro-USB connector on both sides(as below), push RC to
any direction, if the signal on LED displayer keeps the
same pace, then the learning mode is done.
3
2
2
1
1
How to remove:
Learning Mode (Rematch mode):
Loose RC mount
Fix RC mount on handle bar
Clip on
Auto-induction mode: realized by the sensor built in the
transmitter, only available for two signals: cycling signal &
caution signal.
Additional statements:
Remote controlling mode has the priority over auto-induc-
tion mode. The operation system will change to
auto-induction mode 7 seconds after any working signals
except caution under remote controlling mode. If you push
down RC, it’ll remain caution signal all the time and won’t
change to other states until you push RC to other directions.
07
08