Vulcanair S.p.A.
Service Bulletin No. VA-03 Rev.1
First issue dated 09 October 2017
Rev.1 dated 08 January 2019
Page
15
of
19
6.
Insert the Installer Unlock Card p/n 010-00769-60 in the lower slot of PFD.
7.
Keeping pushed the ENT softkey of PFD, push-in the PFD circuit breaker.
8.
Garmin System will turn on in configuration mode. Wait few seconds.
9.
By operating with the larger FMS KNOB on MFD, select the page SYS GROUP and press
ENT.
10.
By operating with the smaller FMS KNOB on MFD, select the page FEATURE
CONFIGURATION and press ENT.
11.
Select and enable the External Video feature.
12.
Press ENT and check that “ENABLED” is shown in the ACTIVE column near “External
Video”.
13.
Pull-out PFD breaker.
14.
Wait few seconds, then push-in the PFD circuit breaker and set the aircraft Master Switch to ON.
15.
Garmin System will turn on in normal mode. Wait few seconds.
16.
Turn the larger FMS KNOB on MFD to the Aux page group. The External Video page is the
first page in the Aux page group.
17.
Check that Quick Cam video is shown.
NOTE
Refer to the latest revision of Garmin G500 Pilot’s
Guide p/n 190-01102-02 for additional information
about zooming, panning and external video setups.
18.
Tag and store in a reserved area the mooring hook removed from the aircraft.
19.
Update the Aircraft Flight Manual at the latest revision.
20.
Record compliance with this Service Bulletin in the Aircraft Log-Book.
