Vulcan-Hart 641 090, Руководство пользователя и инструкции по установке

Страница: 21 / 40

INSTALLATION
21
WATER HEATER LOCATION
The water heater should be installed close to the most frequently used outlet
and its position chosen with safety and service in mind. Make sure people
(particularly children) will not touch the flue outlet. The flue terminal must be
clear of obstructions and shrubbery.
Clearance must be allowed for servicing of
the water heater. The water heater must be
accessible without the use of a ladder or
scaffold. Make sure the temperature
pressure relief valve lever is accessible
and the front cover and burner can be
removed for service.
If possible leave headroom of one water
heater height so the anode can be
inspected or replaced. Remember you may
have to remove the entire water heater
later for servicing.
The water heater is to be installed at ground level on a concrete or brick plinth
or other fireproof base as approved by the local authority. The water heater
must also stand vertically upright with the back of the water heater
against or
within 25 mm of an external wall or alternatively against a fireproof screen
extending at least 500 mm above, below and either side the flue terminal.
Failure to observe this precaution can cause problems in high wind areas. A
secondary flue is not required.
It is a requirement of AS 5601 and AS/NZS 5601.1 to secure the water heater
to the wall. The water heater must be secured to the wall or screen using the
brackets provided.
Kits are available to enable the water heater to be installed partially recessed
into an external wall.
The water heater must not be installed in an area with a corrosive atmosphere
where chemicals are stored or where aerosol propellants are released.
Remember the air may be safe to breathe, but when it goes through a flame,
chemical changes take place which may attack the water heater.