To start using Wireless Mouse
1. Battery Installation
1) Use your thumbs to open the battery
compartment of the mouse and remove it by
pulling back.
2) Insert two 1.5V; type LR03 AAA batteries into
the compartment. Make sure to comply with the
polarity markings.
3) Push forward to close the battery compartment
back onto the mouse again until you hear it click
into place.
2. Establishing a connection between the mouse and the RF receiver
The following steps have to be carried out within 15 seconds if a successful connection is to be
established between the mouse and the RF receiver. Ensure that the mouse is no further than 1.5m away
from the RF receiver.
1) Connect the RF receiver to any free USB port on your
computer. The Plug & Play function of your system will
automatically detect that a new device has been connected.
The mouse will not yet be ready to use at this stage.
2) First, press the Connect button
on the receiver that shown
as
.
3) Then, press the Connect button on the bottom side of the
mouse as
.
4) After a few seconds your mouse will be ready for use.
3. Sleep Mode
The mouse will switch to power saving mode after 3 seconds while working; and power off automatically
in 8 minutes to extend battery life. The mouse will be activated again with one mouse click.
