5
R E I M A G I N E
L O U D S P E A K E R S
WWW.VUEAUDIO.COM
1. AC Power switch
2. Locking PowerCon connector (100 - 240VAC, 50-60 Hz)
3. Cooling fan (rear exhausting, air is pulled in the front of
the amp) Do not block the fan and vent openings.
4. Speaker output A and B - two NL4 Speakon connectors
5. Analog input A and hard wired loop through XLR jacks.
6. Analog input B and hard wired loop through XLR jacks.
7. AES / EBU digital input and buffered loop through XLR
jacks.
1. Front panel network port jack.
2. Power on indicator
3. A and B Amplifier indicators for: Protection and
Temperature
4. Sleep indicator lights when the amplifiers is in power
down sleep mode.
5. Wink indicator for identifying the amplifier over the
network.
6. Input channels A and B meters with input Clip, input
Limiter engaged, -6dB down from full input, and Signal
7. Input channels A and B audio mute indicator.
V4-d FRONT PANEL FEATURES
V4-d REAR PANEL FEATURES
8. Output channel A amplifiers 1 and 2 meters with input
Clip, output Limiter engaged indicator, -6dB down from
full output, and Signal present indicator.
9. Output channel A amp 1 and amp 2 Mute switches and
indicators.
10. Output channel B amp 1 and amp 2 meters with input
Clip, output Limiter engaged indicator, -6dB down from
full output, Signal present, and channel mute indicator.
11. Output channel B amp 1 and amp 2 Mute switches and
indicators
12. Front cooling vent - Do not block vent openings and
clean vent filter when visibly dirty.
8. Two Ethernet port jacks for control with SystemVue
network software and audio input with Dante network
audio. Either port can be used. These jacks are
individual ports on an internal Ethernet switch, so they
can be linked to the next VDrive amplifier in a rack.
When using an external Ethernet switch one
jack should be connected to the network
switch. Connecting both ports to the same
network will cause continents on the network.
Содержание VUEDrive V242
Страница 3: ......