VU LED-32K160M, Быстрая настройка

Страница: 3 / 7

Be sure to disconnect the AC power cord before installing a stand or wall-mount brackets.
Carefully place your TV facedown on a soft,cushioned surface to prevent damage to the TV or
scratching to the screen.
Product image is only for reference,actual product
may vary in appearance:
Accessories List
Installing the Stand
User Manual × 1 Quick Setup Guide × 1 Remote Control × 1 Battery × 2
The TV screen is very fragile,and must be protected at all times when removing the base stand.Be
sure that no hard or sharp object,or anything that could scratch or damage the screen,come into
contact with it.DO NOT exert pressure on the front of the TV at any time because the screen could
crack.
For tabletop use,the TV must be attached to the provided stand as shown on this page.
1 2
Remote Sensor
Receive remote signals from the remote control.
Do not put anything near the sensor, as its function may be affected.
Remote Indicator Red light up in standby mode. Blue light up in power on mode.
STANDBY/ SOURCE
Press for a few seconds to turn on the TV or put the TV in standby mode.
/Touch to select among the different signal sources.
1. Attach the stand to the TV set as shown in the picture. Use the 4 screws to fix the stand tightly.
If you need to use the Wall-mount Bracket, please refer to the below information.
Remote Sensor
Remote Indicator
STANDBY /
32″ Screws: (ST4 × 12F) × 4
32″ Screws: (ST4 × 12F) × 4
200 × 100
M6