INSTALLATION STEPS:
1.
If your monitor is already attached to an arm, remove the top two screws from the VESA attachment and loosen the bottom two
screws. If your monitor arm is NOT attached to the monitor, insert the bottom two screws only.
2.
Slide the Back Plate between the VESA attachment and the monitor as shown in
Image IV
. Position the Back Plate flush and
center against the back of your monitor.
3.
Replace the top two VESA screws and tighten all 4 screws. If the original screws are not long enough, we have included 2 additional
sets of screws. One set of four screws is 14mm long and the other set of four screws is 20mm long. If needed, try the 14mm screws
first. It is IMPORTANT that this connection be “snug.”
4.
Position the Vertical Support Arm on the Back Plate. Thread and tighten the four thumb screws through the slots of the Vertical
Support Arm and into the Back Plate.
(See Image V.)
5.
Attach the Horizontal Support Arm to the Vertical Support Arm by placing the guideposts in the Vertical Support Arm through the slots
in the Horizontal Support Arm. Tighten by threading each of the two black thumb screws in the enclosed plastic bag through the
Horizontal Support Arm and into the Vertical Support Arm. Make sure the slots in the Horizontal Support Arm face upward.
(See
Image VI.)
IV.
V.
VI.
Attaching the VUR 59GR Easel:
1.
Slide the closed circular end of the Easel over the left side of
the Easel Arm, and gently snap the open end of the Easel into
place.
(See Images VII and VIII.)
2.
The Easel Lip attaches to any of the four holes on either side of
the Easel. Slide the Easel Lip into the desired holes and GENTLY
PUSH DOWNWARD until it engages. The bottom two holes are
recommended for full size documents.
VII.
VIII.
3.
To adjust the size of your Easel, gently slide the Easel Lip upward until it disengages. Position as desired.
Attaching the VUR 79GR Easel, see number 1 above.
Angle Adjustment
1.
To adjust the angle of the document, swing out the angle adjustment wire
and place into the desired slot.
Height and Depth Adjustment
1.
To adjust the unit up or down, loosen the thumb screws on the Back Plate and slide into the desired
position. Retighten the screws.
(See Image IX.)
IX.
2.
To adjust horizontally for depth, loosen the thumb screws on the Horizontal Support Arm and slide into
the desired position. Retighten the screws.
HELP
is just a call or click away!
1(800)-678-2629 or [email protected] www.vu-ryte.com
Vu Ryte, Inc. Tyler, Texas USA 75701 - Patented
Vu Ryte, Inc. expressly disclaims the warranty of merchantability, as described in Business and Commerce Code 2.314, and the warranty of fitness for a particular purpose, as
described in Business and Commerce Code 2.315, and the buyer/user of the product expressly disclaims that it has contracted for of received any warranty of fitness for a
particular purpose with respect to the product. THE PRODUCT SOLD UNDER THIS AGREEMENT IS SOLD ON AN “AS IS” AND “WITH ALL FAULTS” BASIS.
Business and Commerce Code 2.315, and the buyer/user of the product expressly disclaims that it has contracted for of received any warranty of fitness for aparticularpurpose withrespectto
theproduct. THE PRODUCT SOLD UNDERTHISAGREEMENTISSOLD ON AN “ASIS”AND “WITHALL FAULTS”BASIS.
