2. Functions for the Buttons :
1 POWER/TALK
ON/OFF
In idle mode: Press to place a call. Press and hold to power the wireless headset on or off.
During a call: Press to end the call.
During registration: Press to exit the registration mode.
2
VOLUME UP
During a call: Press to increase the earpiece volume.
During ringing: Press to increase the ringer volume.
3 VOLUME
DOWN/FLASH
During a call: Press to decrease the earpiece volume.
Press and hold for 2 seconds to do a Flash (R) to answer a second incoming call.
During ringing: Press to decrease the ringer volume.
4 M1
Short press to dial the direct Memory M1. This is for Confort 250/450 and GT350.
5 M2
Short press to dial the direct Memory M2. This is for Confort 250/450 and GT350.
6
RESET
Use a pin to push the button, it will reset the unit when it is found mal-function.
3.
Front LED Indicator functions :
Purple:
Steady On : Un-register
Slow Flash (0.5s On -> 4.5s Off) :
The unit is registered but the base is not available. Searching or out of range.
Blue:
1. Steadily on:
When the PENDANT is seated in the base and fully charged.
2. Steadily on
3s (On 3s -> Off) : Once the PENDANT is successfully registered, the blue light will on for about
three seconds, and emit a long beep.
3. Double flashing (0.25 On -> 0.25 Off -> 0.25 On -> 9.25s Off,
On for 2s when just off hook): Off hook.
4 .Double flashing (0.25 On -> 0.25 Off -> 0.25 On -> 9.25s Off , On for 2s when just off hook): Off hook but
the signal is weak. Hear 3 rapid beeps in every 10s.
5. Long flashing (0.5s On -> 4.5s Off ):
The unit is in idle mode and off the base.
6. Continuously flashing (
0.5s On -> 0.5s Off )
:
The unit is ringing and can be heard through the speaker.
Red:
1. Steadily on:
When the unit is charging on the base.
2. Long flashing :
Indicates that the battery is low, the unit is not on the base, and the unit will emit short double
beeps.
3. Double flashing (0.25 On -> 0.25 Off -> 0.25 On -> 9.25s Off ):
Indicates that the battery is low while the unit
is in use and short double beeps will be emitted.
Red/Blue:
Toggling (0.5s Red On -> 0.5s Blue On) :
The unit is in registration mode after press and hold Vol+ and Vol –
keys for 10s.
