3
Getting started
Add and register a handset
Each newly purchased handset (
CS6209) must be registered to the
telephone base (
CS6219, CS6228 or CS6229
) before use. When first
purchased, each expansion handset shows
NOT REGISTERED.
To make registration easier, read all of the instructions on this page
before you begin. If the handset screen does not show
LOW BATTERY or
HANDSET X
, you will need to charge the handset for at least five minutes
before registering to the telephone base.
To register a handset:
Place the unregistered handset in the telephone base or charger. If
PRESS
FIND HS 4 SEC ON BASE does not appear on the handset screen after
a few seconds, remove the handset and place it in the telephone base or
charger again.
On the telephone base, press and hold
FIND HANDSET for about four
seconds (until the red
IN USE light on the
telephone base turns on) and then release the
button. The handset shows
PLEASE WAIT...
and it takes about 10 seconds to complete the
registration. The handset shows
HANDSET
X REGISTERED (X represents the handset
number assigned) and you hear a beep when
the registration completes.
When the registration is complete, the newly
registered handset is assigned the next available
handset registration number. For instance, if you
already have
HANDSET 1 and HANDSET 2, the
next registered handset is
HANDSET 3.
1.
2.
If the registration fails, the handset shows
NOT REGISTERED
. To reset the
handset, remove the handset from the telephone base or charger and place it
back in. Try the registration process again.
You cannot register a handset if any other system handset is in use.
Only one handset can be registered at a time.
