Getting started
4
Add and register a handset
You can add new handsets (
CS6400, purchased separately) to
your telephone base. Each handset must be registered to the
telephone base before use.
When first purchased,
each expansion handset alternately shows
1.Press FIND HS on base 4sec and 2.Then press # on handset.
The new handset should be charged without interruption for at
least 30 minutes before registering it to the telephone base. For
more details on battery charging, see page 3.
To register a handset:
Make sure the handset is out of the handset
charger and is put near the telephone base.
Make sure the handset alternately shows
1.Press FIND HS on base 4sec and
2.Then press # on handset before you
begin registration.
Press and hold
FIND HANDSET on the
telephone base for about four seconds until
the telephone base shows
Registering...
Please wait, then release the button.
Press
# (pound key) on the handset. The
handset shows
Registering... Please wait.
It takes up to 60 seconds to complete registration. Then
HANDSET X Registered appears on both screens, with
X being the handset number, and the handset beeps. The
handset is now registered with the telephone base.
If registration fails, the handset displays
Registration failed.
Please start again from Step 1 above.
1.
2.
3.
You cannot register a handset if any other system handset is
in use.
The telephone base shows
Registration slots are full when
you try to register more than 5 handsets to it.
If you have not set the date and time for the telephone system,
the handset will prompt you to set the date and time after it is
registered to the base. To skip setting, press
OFF
/CANCEL.
•
•
•